Question Locked

Windows XP Home stalls on startup

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My PC was turned off for about 10 days while I was away. When I booted it up it would get as far as displaying the cursor and then it just sits there (left it overnight). In safe mode it displays the safe mode message at the edges of the screen and sits there. Booting to last known (or for that matter anything else) produces the same result. The NTBTLOG file shows the last driver loaded was Cdfs.sys. I originally determined that it was not recognizing my 500G SATA drive that was attached via an add-on controller. This was true even when I booted up BART-PE even though the disk manufacturers utility saw the drive and diagnostics reported no problems with either the controller or drive. Thinking this was the problem I replaced the motherboard with one that had on-board SATA. However, XP Home hung at the same spot. I have installed XP Pro in another partition so I could get at my files but I have a lot of programs instgalled under XP Home, some of which are old and I don't have the install CD's. I would like to repair the XP home installation if possible but the XP Home CD does not offer a repair of the current installation only the Repair Console. I have not found anything there that would help.

--------------------------------------------------------------------------------

6 replies

by older mycroft

If so, your chances "[i]to repair the XP home installation if possible[/i]" are probably gone now.

By installing XP Pro to another partition on the same hard drive, you have overwritten the boot files on the hard drive for the present installation of XP.

I think that's the end of the old XP ever booting. You'd have to overwrite the boot files with a new installation of XP Home to get it to boot.

I think. ;)

The changed motherboard would be a major compatibility problem anyway.

by thespianiam

I now have a dual-boot setup. I did this in hopes of being able to repair the old install. The irksome thing is that when I boot from the Windows XP Home CD and select "Install" it does not give me the option to "repair" the installation only to install over what is there (i get a warning that there is already an operating system that will become inaoerable) which defeats the purposr of my saving it.

by seanferd

It was set up for the old board. You need to have the drivers for the new board installed.

by thespianiam

I don't know how I can install the correct drivers if I cannot get the system to boot in either normal or safe modes.

This discussion is closed to new replies.