Question Locked

Windows XP is not showing all of my hard drive capacity

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just installed a new Seagate Baracuda 500GB Sata drive in my computer. I used the Sea Tools software & cloned all the data & operating system from the old drive which is a 320GB Baracuda. After cloning the drive I set the BIOS to boot from the new drive & that went fine. However, now the new drive is showing only 320GB instead of 500. How do I get access to the rest of the 180GB on my drive?

4 replies

by rob miners

1. Log on as administrator or as a member of the Administrators group.

2. Click Start, click Run, type compmgmt.msc, and then click OK.

3. In the console tree, click Disk Management. The Disk Management window appears. Your disks and volumes appear in the right hand pane of the window.

4. Your drive will show up as Disk 1 and it should say Healthy (Active, Primary Partition)

To create a new partition or logical drive on a basic disk:

1. In the Disk Management window, complete one of the following procedures, and then continue to step 2:? To create a new partition, right-click unallocated space on the basic disk where you want to create the partition, and then click New Partition.

? To create a new logical drive in an extended partition, right-click free space on an extended partition where you want to create the logical drive, and then click New Logical Drive.

2. In the New Partition Wizard, click Next.

3. Click the type of partition that you want to create (either Primary partition, Extended partition, or Logical drive), and then click Next.

4. Specify the size of the partition in the Partition size in MB box, and then click Next.

5. Decide whether to manually assign a drive letter, let the system automatically enumerate the drive, or do not assign a drive letter to the new partition or logical drive, and then click Next.

6. Specify the formatting options you want to use by using one of the following procedures:? If you do not want to format the partition, click Do not format this partition, and then click Next.

? If you want to format the partition, click Format this partition with the following settings, and then complete the following procedure in the Format dialog box:

a. Type a name for the volume in the Volume label box. This is an optional step.

b. Click the file system that you want to use in the File system box.

You can change the disk allocation unit size, and then specify whether to perform a quick format, or enable file and folder compression on NTFS volumes.
Click Next.

7. Confirm that the options that selected are correct, and then click Finish.

The new partition or logical drive is created and appears in the appropriate basic disk in the Disk Management window. If you chose to format the volume in step 6, the format process now starts.

by oh smeg

You need to reclone the original drive and this time when you setup the Cloning process tell the software to use all of the new HDD available space. Though as I have never used the Seatools Option to do this I'm not sure if it supports that option.

If it doesn't download the Trial Version of Acronis true image echo Workstation from here and user that instead. It supports that option. :)

http://www.acronis.com.au/

Col

by trish44

OK, just made a new partition for the unused space. Thanks for your help!

This discussion is closed to new replies.