Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a microwave primary Internet signal, almost T-1, but want to distribute in a very "treed" area, the microwave is 2.4, how do I make the 156 acre site wireless? Nothing seems to penetrate the leaves and trees,,,is radio the answer?
3 replies
by twegner Accepted solution
Clarifications
by faradhi Accepted solution
So if you must go wireless, you will need to go to something like radio. However, that is a large campus to cover. Your going to have to run wires somewhere even if it is to the AP's.
by sirkozz Accepted solution
802.11 a/b/g could work for your location.
The only way to know is for a professional to conduct a site survey.
There are several ways to provide WIFI coverage in outdoor settings to minimize cabling requirements.
To give you some possible numbers figure 1 AP for every 70,000 square feet for 11Mbs coverage, and roughly $1500 for each AP (cabling, antennas, ect.) not including running 120VAC if required. Install should be under 200K including site survey and elecrtical if required.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies