Question Locked

wireless access point or a range expander to improve wireless connection?

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

How do you decide which to use? I need to improve a wireless connection to the internet for a 2 story space of about 2500sq ft.
Thanks!

8 replies

by nimmo

Alot of wireless access points have settings in them to allow you to boost the signal strength.

If you can't boost the signal or it doesn't have enough signal to cover the area you can install another access point on the network.

Doing this is pretty simple basically you use the same SSID and authentication which creates what is called an ESS.

by amirza

Weather you can use an repeater or no depends on the maufacturer of your current wireless router or access point. If your current router or access point support WDS (Wireless Distribution System) then you can use any device from any vendor which also supports WDS and setup the access point in repeater mode.

Buffalo Tech's WHR-HP-G54 is a great router, this can be switched to Bridge Mode and then setup as a Repeater. Linksys APs also have a Repeater option.

Also look at DD-WRT, you can use their firmware to enable WDS and Repeater functions on many Routers and Access Points.

Also note that everytime you put in a Rage Expnder or Repeater you cut your network bandwidth in half since these devices work in hafl-duplex mode. Do not put more than 5 WDS devices in your network.

Better if you can run ethernet and connect APs to extend the network.

by technogeek-1995

What if you do not have WDS. I am trying to do the same thing with 2 Linksys WRT54 routers.

by nimmo

If you have two wireless routers put the same SSID in them change them to different channels, and make sure the encryption/authentication is the same.

This will created an extended service set which will allow greater distance because you have two access points that can be used to cover a larger distance

by michael kassner

If you haven't selected any equipment, I would strongly suggest a mesh networking approach. I know that Meraki Network equipment would be ideal for your situation and it's not that expensive. Check out their website.

http://meraki.com/

by technogeek-1995

It didn't work. You have to do more...connect the 2 via Ethernet. Or more in settings??? PLEASE TELL, I am doing the same thing (see projects for more info)

by scank

how many users are we talking about?

if only a few then asus 330 is a pretty good all in one apart from having no external ariel (ok for 2500sqft unless it is <5ft wide!).
i dont work for asus i don really worry about extending home wireless networks on account of living in a shoebox in london. but i am reliably informed it is easy to set up and does the business

This discussion is closed to new replies.