Question Locked

Wireless network

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I need to set up two linksys wireless routers.

One the first floor the second on the second floor. The router on the second floor is connected to the internet. I have connected to two together use cat5 wires.
They are conneted port1 to port1. I disabled the DHCP and changed the IP address of the second router to 192.168.1.2. second I can get on the internet from router one but not router two.

I have checked all the setting on both routers and still can not get an Ip address from the second router.

What else must I do.

3 replies

by georgeou

Are you using a crossover cable? Go to the router interface of the second router and see if you can ping the first router.

If you intend to use both Wireless Access Points, you can set them to the same SSID which allows for roaming though they're probably too close to roam if coverage of either AP is strong in the house. You should set them to channels 1, 6, or 11. 6 is commonly used by neighbors so I'd lean towards 1 and 11.

If you use different SSIDs, you can better control which AP you're connected to.

by triathlete1981

then how are people getting to the internet. if you disabled dhcp on the first wireless router to accomodate the static ip of the second router, then how are people getting ips?

and wireless security blows. go land-line. it's the wave of the future. (joke)

unless you're in love with wireless.

This discussion is closed to new replies.