5 replies
by scotchtkh2002 Accepted solution
by older mycroft Accepted solution
by scotchtkh2002 Accepted solution
by jck Accepted solution
unless the USB interface is more than just USB.
Your USB dongle on the drive would have to know the address of the other USB dongle. So you'd have to configure them both statically in your router.
It's possible it could work, but I don't know if there will be any syncing issues because of the routing through your router delays and signal loss/degradation issues.
if you can configure both dongles then establish the device somehow from the PC and make the PC dongle talk to the drive dongle...it might work.
i've never tried it though, and it seems like to me there would be issues there somehow. I just can't put my finger on why.
Edit: I just thought of why. Your hard drive probably doesn't know how to default setup communications with another USB device like your PC does through a driver.
You could put another PC in the location where the drive is, if you have one that is.
by rob miners Accepted solution
You would need to run Power and Cable from or to your Locker. You would need to be plugged into a Power Outlet that has a switch to be able to Power on/off the Device. Depending on the distance from the Locker the USB Cable may have to be piggy backed with a Powerd Hub.
Easy to setup all you need is a Holesaw big enough to drill a hole into you Locker that will accomodate the Power lead and Cable. The External Drive would have to have room to breath and not get too hot.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending