Question Locked

Wireless Router and Switch

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a cable modem, 5 port Gigabit Switch and a wireless N (w/ non gigabit switch). I have the ethernet cable coming from the modem to the gigabit switch and then a crossover cable going to the WAN port on the wireless router. If I am connected to the wireless then I get the internet fine. But if i am connected to the gigabit switch via ethernet then no dice. What is the issue here because obviously the gigabit switch is getting connectivity or the wireless router could not provide me with the internet. Right?

What is the issue here, I'm ready to experience gigabit speed!

Cecil

3 replies

by ken

The modem should be plugged into the "internet" or WAN port of the router. You can use a regular cable between the router and switch as most new equipment will "auto negotiate" the connection, but the cross over should also work

by older mycroft

Have you disabled the wireless capability first ?

If not, you are confusing the computer system by presenting it with too many options ~ Wired and Wireless. As a result it will fall over because it cannot decide which comms mode to use.

This discussion is closed to new replies.