Question Locked

wireless router - strong signal - no internet

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We recently purchased netgear WGR614 v9 wireless router. Went through the installation steps and when laptop is connected hardwire - internet works fine. But once we try wireless, the signal strength is strong but we can't connect to the internet. Here is our ipconfig info. We are at a loss - any help would be great.

Host Name . . . . . . . . . . . . : becky-721c4c3a5
Primary Dns Suffix . . . . . . . :
Node Type . . . . . . . . . . . . : Unknown
IP Routing Enabled. . . . . . . . : No
WINS Proxy Enabled. . . . . . . . : No

Ethernet adapter Local Area Connection:

Connection-specific DNS Suffix . :
Description . . . . . . . . . . . : Broadcom NetXtreme 57xx Gigabit Cont
roller
Physical Address. . . . . . . . . : 00-14-22-BA-05-F7
Dhcp Enabled. . . . . . . . . . . : Yes
Autoconfiguration Enabled . . . . : Yes
IP Address. . . . . . . . . . . . : 192.168.1.2
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . : 192.168.1.1
DHCP Server . . . . . . . . . . . : 192.168.1.1
DNS Servers . . . . . . . . . . . : 192.168.1.1
Lease Obtained. . . . . . . . . . : Thursday, January 22, 2009 7:21:13 P
M
Lease Expires . . . . . . . . . . : Friday, January 23, 2009 7:21:13 PM

Ethernet adapter Wireless Network Connection:

Media State . . . . . . . . . . . : Media disconnected
Description . . . . . . . . . . . : Dell TrueMobile 1300 WLAN Mini-PCI C
ard
Physical Address. . . . . . . . . : 00-10-C6-C8-C0-FC

4 replies

by oh smeg

And this time include the PassPhrase when you are asked about Security Settings for the Router.

You should also revisit the Net gear's setup Procedure ad change the password & PassPhrase to something different from the default to retain security. That is the Password & PassPhrase that you enter when you log into the Router this will prevent others stealing your WiFi connection.

Col

by .martin.

if Access Control is turned on (you don't want it to be when you set up the router)

to find it, it is under advance wireless settings, then setup Access list (may be different in v9, I use v7).
The check box for turn access control on, should be unselected.

by pure_star12

So to my understanding if the router is connected directly to the computer via the ethernet cable it is able to connect to the internet but without it. it's not have you installed a wireless adapter card into the computer?

This discussion is closed to new replies.