Question Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hi.I have a Canyon CN-WF514M 4 port wireless router Which I am using for a wireless network on one side of a factory. I then have a CAT5 cable plugged into one of the ports which then runs 85meters to the other side of the factory. I have a standard 5 port 10/100 switch hub (which I know works) at the end to boost it to run another 45meters. If I plug the 85m cable directly into my laptop (where it would go into the 10/100 5 port hub)(with server assigned IP Address) I can see the wireless router and browse to other machines on the wireless network. I then unplug the 85m cable (which runs directly to the wireless router) from my laptop and plug it into the 5port 10/100 switch and then a fly lead from the hub to my laptop, I cannot ping the machines and the wireless router anymore. I have switched off the DHCP on the router - no change. I would like to leave it off anyway as one of the machines on the other network (which i ultimately want to connect to) has a DSL router with DSL connection. What am I missing in the config of the Canyon Wireless?
6 replies
by james.tintinger Accepted solution
Clarifications
by ic-it Accepted solution
Seems like when you are connected (before the hub) all is in order. That would mean that either the cable to the hub is plugged into a wrong port or that the short cable (hub to laptop) is a crossover cable or simply bad.
by sgt_shultz Accepted solution
but i would expect you might still work even at that length. do you have link lights everywhere? if no, check for correct uplink ports and hit the support section of the websites of your switches as you might be using an illegal port
if yes, check for media type mismatch. perhaps try locking down to 10mb half duplex on your laptop nic for a test
by ic-it Accepted solution
You may have nailed it on the length alone.
by sgt_shultz Accepted solution
thanks
by james.tintinger Accepted solution
I have tested both cables (I can connect directly to the wireless router ports with both and browse the network) and the hub, all work properly and there are no crossovers. its simple that when I add the hub in before my laptop, I get 100% network connectivity but can no longer get a reply on Ping. I hear you about the uplink, but, to my knowledge my hub does not hat that separate "1x" port. but I will check that thanks.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies