Question Locked

Wont boot, no Vid, nothing but power!!

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My computer will no longer boot. The system has power, fans move, light up but nothing else...Also, cannot shut down system from front of case. I have tried to remove all non-critical parts, reboot and get sounds but still no beeps or anything...any suggestions? Most internal hardware is non-refundable at stores so I cannot "try" hardware to fix the system...what to do?

6 replies

by hal 9000

And have not stated if this is a new build or one that has been running for some time the best option would be to take it to a Computer shop and get then to fault find on the system. They will have other Hardware components that they can use to test things with and work out what is wrong. It will be your cheapest way out of your current problem.

If this is a new build the most obvious thing is that the Video Card will not work with the M'Board I've seen this quite a lot particularly with non Intel Chip Set M'Boards, but as you haven't said anything one way or the other it's impossible to say.

So take it along to your local computer repair place and get them to at the very least to Fault Find what your current problem is.

Col

by johnsk613

this is a system that has worked fine previously....

by hal 9000

That is most likely not producing enough power to start the system. I always recommend Antec Power Supplies because they are rugged work extremely well and are underrated for their power output.

Col

by rob mekel

Have you tried to power your pc viewing the lets on the M'board? (if there are any)
If lets don't get any power ... probably the M'board doesn't get the power.
Or measure the power on the M'board connection which will give you the same result. The internal speaker is one of the first items to get power of the M'board so if it doesn't "beep" probably the M'board doesn't get the power.

You can also take the power in to a computerstore (or other store that has the equipment) to check the power.

Rob

by intrepi

I'm not sure as to what you've installed or what your power supply is rated for but a lot of times when a new graphics board is added and the power supply can't meet the new demand, it fails. Take a look at the power supply you have and if it's 250 or 300 watt, chances are it has failed. I'd recommend taking out the power supply and install an Enermax 535 watt power supply as a minimum and consider 600 watt or more if you have a newer high end mother board.

This discussion is closed to new replies.