Question Locked

workgroup is not accessible

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
workgroup problem

2 replies

by johnjackson1132

Hm. Really need more details but...a few things you can do. First...check and make sure all the computers are on the same network. To do this..

Start --> Run --> CMD (pres_enter), then type "ipconfig" no spaces, no quotes.

This will show you everything about your open LAN connection. Write down the information, especially the default gateway...and do this to every PC, only takes a minute...verify all PCs are on the same sub-net.

Once you've established they are all on the same sub-net, go back into CMD prompt, via steps above..and use the syntax..."ping IP Address".

IE:ping 192.168.50.254 Space after the ping, and enter the IP address, and verify from on PC, that you can ping every other PC...this will assure you that you are on a network.

Next...make sure you are all on the domain still, this is important if you share printers/files, etc...Right click "My Computer"..select "Properties"...and select "Computer Name" verify everyone is on the same workgroup.

Hope this helps!

This discussion is closed to new replies.