Question Locked

Wrong conifg-reg in Rommon, unable to recover

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently bought an old Cisco 2500 Router and had to reset the password, so I fixed it and configured the router to enter the wrong config-reg at its next reload. When I reloaded it, I just got a bunch of meaningless, redundant symbols and letters. Is there anyway that I can fix this? It is operating using a 10.3 Cisco IOS. --Yeah, old.
I have several other 2500 routers, but do not have any flash cards or a backup on my TFTP server. Help!!?!?!

5 replies

by robo_tech

I do have access to the IOS's off the cisco site, I just have never tried it. That's what I will probably have to resort to doing. Thanks.

by cg it

try changing your config register back to the run condition. 0x2102

by robo_tech

I can't. The only symbols/characters that come up every time I give the router power is xxxxxxxxxxxxxxxxxxxxxxxxx. --Just x's. When I type, or try to interrupt the "boot process", it gives an output of the letter "x".

This discussion is closed to new replies.