4 replies
by drjeep1959 Accepted solution
by Former member Accepted solution
by jlips50 Accepted solution
I had a similar problem when adding a drive.
I had reloaded xp pro and when finished I had just the single drive. Later on after taking all updates and upgrades to sp2 lo and behold there was my second drive Yeah!
by maccman23 Accepted solution
I've had a similar but bizarre experience. My xp home
system 'lost my WDC 2500JB Slave drive. i run a maxtor
ide 160gb master plus a 250gb sata drive. i have tried
checking all the cables etc and no luck. Then.....
i decided to unplug the master and the sata and tried the
slave on its own. it let me install xp and works perfectly,
yet when i tried to put everything back the way it was,
same again, the other two drives work fine yet the wdc
appears in the bios( it even auto detects it) but it doesn't
show in device manager or computer managemnet.
it would be easy enough to run it as a slave drive but i
don't fancy reinstalling all my progs on it just in case
there is a deeper problem.
i went back to the config where the slave became the
master and an am running a scandisk as we speak but if
this doen't work i'm stumped.
if it works as a master surely that signifies all the cables
are ok( the sata and the original master work ok in this
config) but doesn't work in my original config.
anyone seen this before?
Thanks
Dave
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending