Discussion Locked

XP PRO needs Lan Repair after power down

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

XP PRO needs Lan Repair after power down
Please Help, I do not know a lot about LANS. I am running Windows XP Pro at home with a Netgear MR814 router, connected to a 3Com DSL modem.

Every time I power down my PC, I need to REPAIR the LAN connection to be able to access the Internet. My Laptop using the wireless connection is able to access the net OK; it appears to be a communication / config issue between the PC and Router.

Any ideas would be greatfully accepted. Thanks.

4 replies

by joseph moore

Microsoft Knowledge Base Article - 289256

A Description of the Repair Option on a Local Area Network or High-Speed Internet Connection
The information in this article applies to:
Microsoft Windows XP Home Edition
Microsoft Windows XP Professional

This article was previously published under Q289256
SUMMARY
This article describes what actions are taken if you select the Repair option on a local area network (LAN) or high-speed Internet connection.
MORE INFORMATION
The following actions are taken if you select the Repair option on a LAN or high-speed Internet connection.

NOTE: The actions occur in the order that they are listed. A corresponding command is listed next to each action.
Dynamic Host Configuration Protocol (DHCP) lease is renewed: ipconfig /renew
Address Resolution Protocol (ARP) cache is flushed: arp -d *
Reload of the NetBIOS name cache: nbtstat -R
NetBIOS name update is sent: nbtstat -RR
Domain Name System (DNS) cache is flushed: ipconfig /flushdnsDNS name registration: ipconfig /registerdns
The following action has been added to Windows XP Service Pack 1:
IEEE 802.1X Authentication Restart

by joseph moore

So, that is what Repair is doing, step by step, when you run it.
So, I would NOT run Repair when you reboot, and instead run each step manually. See which step is fixing your connectivity. At that point, you will know what the real problem is.
Maybe your machine is not able to get an IP address when it comes up, and the IPCONFIG / RENEW takes care of that. That would tell you a problem with the IP drivers, in which reinstalling the IP stack would fix that. Just an example.

So, run each step one at a time, see which one fixes your connectivity problem, then deal with the underlying problem that that step fixes!

hope this helps

by tom_ottawa

Poster rated this answer.
The problem was also resolved with IPCONFIG /RENEW.
I reset the TCP/IP and it appears to have solved the problem. However, it still takes about 15 seconds after loging in to the desktop which is causing some programs to think there is no connection on boot.

This discussion is closed to new replies.