Question Locked

XP Won't boot after running SFC /scannow

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an XP home running SP3 and Nortons Security centre that would not load the desktop icons and or the start bar but would allow access to Task Manager. As a result of some digging decided that explorer.exe was coruupted. Ran from command line sfc /scannow. Carried out a reboot after and now the pc will not boot into any option (safe normal or last known good)Is my only option to insert the orriginal disk boot to the cd rom drive and run a repair install?

9 replies

by robo_dev

Either boot into recovery console, with CD and fiddle with fixboot, fix mbr, etc, or just bite the bullet and do a repair install.

Are you sure you don't have a virus? It would survive a repair install.

by robert.newton

Fix MBR did nothing there is no virus as I have cadied the hardrive and checked with a clean PC running Sophos and found nothing. Doing a Repair Install as last hope today will let you know how I get on.

by shasca

When you System File checker it will do repairs if it can. If it can't it will prompt for the install disc to pull files off it needs to finish the repair.

Hopefully it isn't totally confused at this point and will finish the repair by inserting the disc.

If not you may be stuck doing a repair of the OS.

Let us know.

by robert.newton

Have checked most things looks like the repair install is the last option I will let you know how I got on tomorrow

by shasca

It's really scarry the first time you do it. Just be careful and read each prompt before continuing. It doesn't destroy data unless you do a clean instal and format. The latter would be a good option if you didn't have anything that needed saving. You would have to reinstall any non system applictions, but the it would run like new again.

by robert.newton

I went to run the repair from the disk only for it to say that it did not reconise the partition. Rebooted and ran in recover console and ran chkdsk /r and it returned with parts of partion contain unrecoverable sectors immeadiately. Whent in manually found most of the data intact. Then ran a dir list on system32 folder and it bombed out with i/o error mid way through the D's. Only option left to put new harddrive in reload os and programs and copy data that is accessable from old drive to new via USB caddie. If you know of any other ways I can get round it then I'm all ears otherwise I will let you know how I get on when done.

by tardcart

There is a tool I've used in the past with quite a bit of success called PC Check. It has the ability to scan a disk, recover data from bad blocks and mark the blocks bad so the OS doesn't write to them again. The last version I had only supported IDE but there might be a newer version that supports SATA if that's what you have. It's very effective, but depending on the size of the disk can be a very time consuming process. Even after that though, your just prolonging the inevitable but it does give you an opportunity to ghost the disk.

by shasca

You would be best served if you could get it into a second PC as a slave drive. The OS doesn't need to load for the files to be accessible for backup. Be aware though I have had drives that I couldn't access this way because of several decline. Data recovery software is available but only for a price. If you choose to go that course "WinUndelete" is an excellent product for less that $100.

Good luck!!!!

This discussion is closed to new replies.