Discussion Locked

2nd hard drive not showing up

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i had a 2nd hard drive installed on my computer and it was working for about a month now. one day i had to reboot my computer and when it came back on, everything started running slower for some reason. i clicked on my E:drive(my second hard drive), under My Computer, and a message popped up saying, E:\is not accessible The parameter is incorrect. i dont understand what this message means,and i've also shut off my computer to check the cables connecting the hard drive and everything and the same thing keeps happening. I have windows 2000 by the way, so if you have any information that could help this problem, please do so.
Appreciated

5 replies

by thevirtualone

Can you tell us what brand of hard drive it is? Oh.. and did you install any other hardware recently? like an optical drive?

by deadly ernest

If, like most people, you put the new hard drive on the same IDE cable as the first, try switching it to be the master drive on the secondary IDE cable. If you have a CD make sure that it is the slave on which ever cable you put it, best as the secondary.

Some cheaper drives do no like being the slave drive.

by deadly ernest

One thing that we may have overlooked - have you checked that the hard drive parameters as shown in the BIOS are correct for the hard drive you are using? If the BIOS has a different number of heads and cylinders or size to what the HDD actually is the system would have difficulty reading from the HDD but would still find it in BIOS just not read it in the O/S.

by sysengineer

Here are some things I would try:
1. Replace the cable.
2. Double-check the jumper settings on the slave,
some drives like to be jumped as CS (cable
select) rather than a slave.
3. When starting up your system, take a look in
the BIOS and make sure the drive is still
being recognized.
4. Check the disk configuration in the computer
management snap-in to make sure its there and
working properly. (Start > Run > compmgmt.msc)
5. If all else fails try add/remove hardware
wizard located in the control panel....

...or the drive just may be bad.

This discussion is closed to new replies.