Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Windows NT Server. A Fiery XJ + 300 server attached to a Minolta CF900 color copier/printer/scanner. I have the Fiery Utilities loaded on a Windows ME workstation, which up to last Friday worked fine. When I start the Fiery Spooler (monitoring application) from the Windows ME workstation, I get "-5 General Network Error." However, I am able to print from the Fiery Downloader (fiery utility) application - it will print a list of the fonts installed on the Fiery XJ + 300 server. Also, from the Fiery Calibration utility, I am able to print the calibration test page. I have cleared the server when re-booting.
5 replies
by archibald
Lets see what old Xerox says..... Hmmm not much.
However I have googled your question and see you have asked around.
Here is XEROXs page http://www.xerox-techsupport.com/57xx_Fiery/xj/
Hope it helps some
by jcampos
The question was auto-closed by TechRepublic
by archibald
Lets see what old Xerox says..... Hmmm not much.
However I have googled your question and see you have asked around.
Here is XEROXs page http://www.xerox-techsupport.com/57xx_Fiery/xj/
Hope it helps some
Also, you can try the support forum there
by jcampos
The question was auto-closed by TechRepublic
by jcampos
This question was auto closed due to inactivity
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
0 helpful
1 reply
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies