Discussion Locked

64m SDRAM only recognized as 16m. Why?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I've a Gemlight motherboard that has just one DIMM socket and four simm sockets. Leaving the simms empty and placing a 64 APACER unbuffered 100 DIMM in socket on boot only 16m is recognized. Any ideas?

7 replies

by loydster

I've seen that many times, and either the RAM is bad, or it is the wrong RAM for that motherboard.

by dmiles

Boot the computer and at startup screen press the key to enter CMOS panel,locate the section for memory and see if is recognized or that memory is limited,highlight and hit enter yo can change the value
The other possibility is that the bios may need flashing to update

by thechas

You have an older mother board.
The structure of SDRAM DIMMS was not completely defined when your MB was built.

The newer DIMMs are structured a little bit differently than what the designers of your MB planned on.

So, what you need is a different DIMM.
You either have to find an older PC66 DIMM, or order specific memory from one of the major memory manufactures. (Crucial, PNY, Kingston all offer the older structure DIMMs)

One of the differences is the number of clock lines. At some point, the number of clock lines switched between 2 and 4.
Both Kingston and Intel have papers on this subject.

Some of the older MBs also have limits on DIMM size. I have one that is limited to 2 32MB DIMMs. A friend has a Gateway that is limited to 2 32MB SDRAM DIMMS, but can take 2 64MB EDO DIMMs. Both can have 256MB of SIMMs installed.

Another reality of these early DIMM MBs is that you can have more SIMM memory than DIMM.

I would try to find the MB manufacture if they are still in business. They may have a BIOS update available to correct this. Or may have details posted on the memory limits of your MB. Check out www.motherboards.org for help in finding the MB mfg.

This discussion is closed to new replies.