Question Locked

Adding ports to a Westell Versalink 327W

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Westell Versalink 327W wireless 4-port DSL modem supplied by my phone company. I need to add a few ports for some NAS devices that I am purchasing. I've read information on how to set up a similar network by linking a non-wireless modem to a hub, then adding a wireless router to the hub. My question is, can I do the same in reverse using the hardware that I have now (i.e. linking the wireless modem to the hub while still retaining the wireless connectivity)? If so, can I still use the ports on the modem, or do I need a hub big enough to move all current and future devices to? Can I still use the modem's firewall? Any specific settings that I need to change?

Also, I'm not sure of the technical differences between a hub and a switch so I'm using the term hub to mean either or. Please advise if one is better (or more appropriate in this scenario) than the other.

4 replies

by hal 9000

Is disconnect one computer and add a Hub with sufficient Ports available and a Patch cable from the 4 Port Modem to the Up link Port of the Hub. Then plug the disconnected computer into the new Hub.

Nothing should be affected unless you have restricted the available IP Addresses in the Modem Setup.

Col

by chris

Thanks Hal, that sounds easy enough. I read up on switches vs. hubs last night - would it be better to get a switch or is a hub really what I need here?

by hal 9000

But I suspect that here a Hub would be as good as a Switch as I don't think that you want to go the the added expense of using a Switch and then properly installing it so that you can manage it. Switches are very useful in large environments but for only a small number of computers it's cheaper with a hub and less hassle.

Col

This discussion is closed to new replies.