Discussion Locked

Alcatel speedtouch usb adsl modem kills phones

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When the Alcatel speedtouch usb adsl modem is connected the phones go dead.

Compaq pc

Windows xp home service pack 2

Thanks Peter

13 replies

by rindi1

Is this ISDN or Analog? How have you connected the modem to the phone system? Check your manual, you have probably not connected your modem correctly to phone line..., or are using a ISDN Modem on a analog system or vice versa...

by peterbakker

Poster rated this answer.
Turned out to be a faulty modem in fact the replacement modem was also faulty Thanks Peter

by carlos.nino

You'll probably need ADSL phone line filters. You have to put them in all the phone terminals that you have. They're not expensive.

by peterbakker

Poster rated this answer.
Turned out to be a faulty modem in fact the replacement modem was also faulty Thanks Peter

by bobho

If the modem connects and works but the rest of the phones are completely dead then I would look to the physical phone wiring in your home/office or go back to the provider and let them know.

I had a similar situation with regular phones where a user had the connection wires crossed on 1 extension. When they picked up that extension all the other phones died. If they used any other extension would kill the first phone. Correcting the wiring solved their problem.

Cheers.

RW

by peterbakker

Poster rated this answer.
Turned out to be a faulty modem in fact the replacement modem was also faulty Thanks Peter

by thechas

I fully agree with ReWrite.
Some or all of the phone wiring is backwards.

You can pick up a low cost phone jack tester at Radio Shack that will tell you if the phone wires are in the proper phase.

Another possibility, is that a transformer is connected to the phone line to provide power to light up the old Princess phones. This could also cause a problem when the DSL modem is connected.

When I install DSL, I install a POTS splitter right where the phone line enters the residence. This way, you have just 1 filter and it is easy to check if there are phone line problems.

Chas

by peterbakker

Poster rated this answer.
Turned out to be a faulty modem in fact the replacement modem was also faulty Thanks Peter

by hal 9000

Firstly have you checked the filters to see that they actually work?

Chas has the right idea and the recommended one if more than 3 extensions are used.

Just how many phones are we talking about here?

What you will have to do is check the REM number on each device connected to the phone line and then ring the phone company to see what they support in a REM number. If you are exceeding this figure the phone system will at best be unreliable.

Also I'm taking it for granted that there is no phone system in place that the ADSL is running through like a PA BX or something similar. If there is the ADSL line should be removed from this system and be on a single line by itself.

However if it is a multi extension phone system on a single line you should install a filter outside the residence and/or cut down the number of devices connected. A wireless phone in a situation like this can remove the need for a lot of extensions. This is a really cheap alternative to having more than usually 4 devices connected at the same time.

Col

by peterbakker

Poster rated this answer.
Turned out to be a faulty modem in fact the replacement modem was also faulty Thanks Peter

This discussion is closed to new replies.