12 replies
That computer most likely has what's called a "socket 7" motherboard. (Socket 7 - the "socket" into which the processor is placed.)
Socket 7 uses the Zero Insertion Force (ZIF) socket. As its name implies, the ZIF socket is designed for ease ofmanufacture and so that the average computer owner will be able to upgrade the microprocessor. The ZIF socket contains a lever that opens and closes, securing the microprocessor in place. Various sockets have a differing number of pins and pin layout arrangements.
Look at the board. It should have the words "Socket 7" along the side of the slot where the processor is sitting.
It's been a while since I've had one of these, but I believe the Intel Pentium 233 MMX or the AMD K6 233 were thelast chips to use that particular technology. Cyrix also had a version of the 233 MHz chip.
I don't think you could find a new one anywhere. You could probably find a used one on ebay.
However, keep this in mind, you may or may not have to upgrade you r BIOS to acommodate such an upgrade.
Good luck,
Maxwell
.
.
Take a look at these sites:
http://www.uktsupport.co.uk/pb/mb/680.htm
http://www.uktsupport.co.uk/pb/mb/640.htm
(REMOVE SPACES from the pasted URL.)
One of those is your motherboard.
The appropriate site will have all the upgrade information and specifications you'll need.
I noticed that both of those boards indicated that the 200 MHZ was the fastest chip it would support. Although a 233 MHz would physically fit into the board, the system BIOS may or may not recognize it.
Maxwell
by eerbrb
by thechas
Have you tried the Packard Bell Support link?
http://www.priorityonesupport.com/
You need to sign-up, and then you can find the specifications for your system.
If it is a socket 5 system, 133 may be the maximum. Socket 7 would give you more options, but still may be limited to a 166.
Another option would be PNY for upgrade processor kits.
by eerbrb
by mic3
post again with exactly the model of pb bell all pb pc's have names old one are executive mutimedia 900 -9000 series
i can tell you the info you need have links with pb
cheers
by eerbrb
pac-bell also had a few m/b suppliers (different manufacturers) check driverguide.com and run it's
numbers. you maybe able to grab a bios up grade that way to.
if it is socket seven there right 233mmx is the max.
however most of these boards will over clock a p200 to p233 with no problems ( set cpu volts for cpu but clock jumpers to 233)
{ MAKE SURE YOU USE A FAN }
I have over clocked a few of these chips up + 20% with out problems
p200 mmx chip's were common and are still easy to find.
by eerbrb
by selcomserv.
by eerbrb
by eerbrb
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending