Discussion Locked

BIOS update

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hardware: HP Pavillion 8665c PC
O/S: Windows 98 SE

I updtated my BIOS per the HP web site. (http://www.hp.com/cposupport/personal_computing/software/merc_210.exe.html). I believe the update was successful as the BIOS lists the new version.

However, I am receiving an error message when rebooting.

During reboot, I receive the following error:
"Expansion ROM not initialized-PCI Mass Storage Controller on
Motherboard.
Bus:01, Device:OB, Function:00"
(Note: I have installed a SCSI card(in a PCI slot) for an external hard drive and have
added 128mb of memory for a total of 256 mb.)

It gives me the option to hit F1 to enter set-up or F2 to resume.

If I hit F1: It takes me to the BIOS screen, where per the update instructions, I hit F5 to update settings and F10 to save settings and enter to exit. It then reboots back to the same error above.
If I hit F2: It asks me to proceed with an update (Y/N).
If I choose
yes,
then I get the following error:
"Cannot flash when memory managers (e.g. EMM386) are present."
If I choose no, then it reboots to windows.

I do not want to go through this process every time I reboot.

Please help so that I can boot without any errors.

Can I take my BIOS back to the settings prior to this upgrade?

Can I set the BIOS not to scan the Expansion ROM?

al@equestsolutions.com

2 replies

by mannyrod

If you can still get into your BIOS, try the Load Optimized Defaults option then save & exit (F-10). While you're in BIOS you should check in PnP/PCI Configurations and make sure the Resources Controlled By is set to Auto(ESCD).
Hope this helps.

by al

I was unable to locate any screen or option within BIOS that allowed me to "Load Optimized Defaults."

In the EXIT Screen of the BIOS, I did set "Load Default Configuration", however that did not solve my problem.

Furthermore, within the PCI/PnP Configurations Screen, there was not an option for "Resources Controlled By" to be set to Auto(ESCD). It only allowed me to make IRQ's "Available" or "Reserved", which did not solve my problem.

This discussion is closed to new replies.