15 replies
by overclocker
by vitosemat
by vitosemat
by s6xtyn9ne
by vitosemat
by lord ago 1
You can try a program called KillCMOS. You can find it at neworder.box.sk Just read the page and you should be able to find it.
You have to set it up on a bootdisk.This will reset all CMOS data to factory defaults. You may have to change a few things to where they should be but other than that, it has proven very useful.Also on that site are other ways to get into the BIOS setup that could prove useful in other cases.
Have Fun!!
by vitosemat
by paulp
It would have been helpful if you had included the model number of the laptop. Assuming it's a ThinkPad, here is what IBM says about resolving a forgotten power on password.
Note: Do not forget your Power On Password! If you forget your power-on password, you cannot reset it. You have to take the computer to an IBM authorized reseller or IBM marketing representative to have the password cancelled. Proof of purchase is required, and an additional charge might be required for the service.Once again, this comes directly from IBM. Visit here for the complete article.
by vitosemat
by shmaltz
by vitosemat
by daravon
Depending on the brand, there is usally a keyboard shortcut to reset the BIOS/CMOS. For example, Compaq laptops: hold Funtion key while pwoering on, then hit F11 until a message appears. The website of the manufacturer should have it on their website.
Jeremy
by vitosemat
by vitosemat
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending