Discussion Locked

Boot up

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
PC --- Runs the POST fine, Windows 98 logo screen comes up fine, after that I get a screen of multiple lines. I believe it must be an error message because when I hit escape and y (twice) it will automatically shut down the computer. I have run Scandisk--no errors, I can get it to boot to Safe mode (sometimes). Help, please

7 replies

by krunch

Sounds like you may have a video resolution problem. See if you can log into safe mode and you'll have to see if changing your resolution helps you out. You may have the wrong monitor type selected or you may have the wrong video card selected. What I would do is get to a resolution you can work in (it may be 640x480 where you're used to 1024x768) but at any rate - get to a resolution you can work in and download the latest drivers for your video card. Update that and see if that helps. HTH! Good luck.

by evsears

Krunch,

Thanks a bunch for the help. I will save it for the future, I know sooner or later I will need this advice. Found out the solution --- apparently emachines will not work with just any monitor. On top of which the girl had the Key Panic Trojan virus. Finally got everything fixed (at least for now). Thanks again for all your help.

by cyberjm

What you could is take out any hardware that you don't need, like modem, sound card, and 3rd party addons, usb, stuff like that.. Reseat the video card and reboot the machine. Most likely with video problems, you will get warning beeps at POST. if you don't, it could be a conflict, a driver issue or a bad seating of the card.

If the above fails, you can try another video card.

If that fails, you may have a virus that has corrupted your master boot record. You would have to run FDISK again(repartition), fix the master boot record, format you hard drives and try to load windows again.
Hope this helps, it will take you some time though. Good Luck!

by evsears

CyberM,

You were right. It turned out to be Key Panic Trojan virus. It finally came up tonight when I was working on it still. I also found out that emachines are not necessarily compatible with just any monitor. That was the second half of the problem. Thanks again for all your help.

by moodystrings

If you can boot in safe mode then do so and try to remmber what you did before this problem happened. Installations, adjustments etc. And uninstall, re-adjust etc. If you do not remember, try going to system information and listing through it to seewhat is red marked and then come back and post again.

by evsears

MoodyStrings,

I appreciate all the assistance you gave. I actually had done your suggestions several times. Turned out to be the Key Panic Trojan virus and the fact that emachines are not necessarily compatible with just any monitor. Thanks again for the response.

This discussion is closed to new replies.