Discussion Locked

Boot up from IDE instead of SCSI

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Have a system with 1 IDE & 2 SCSI HD. It was booting from the SCSI before. After ghost from SCSI to IDE, want to boot from IDE instead of SCSI. Have tried to disable SCSI from MB & SCSI controller. Any idea?
Thx in advance!

11 replies

by mphoffar

Have you set the boot order in the bios from say scsi, c, a to c, a, cdrom or whatever shows c first?

Mark

by chad dykstra

Are you removing the old hard drive?

First and foremost, check your SCSI BIOS settings and verify those are all set..also, not sure what file system you're using but if it's FAT32 you could go into FDISK and set the active partition to the IDE and remove it from the SCSI (which if you ghosted should already be on the IDE) If it's NTFS or other, there has to be another utility that does the same thing, just not sure what it is :-) Good luck

Chad

by marcom

make sure your boot order in the bios set-up program is set correctly. also your master boot record must be located i within the first 1024 (aprox 8GB) cylinders of your hard disks starting a c drive. you may also need to reconfigure slave/master settings
on all hdd's

Good Luck- Mark

by dmiles

You will have to change the SCSI HARD DISK id no to something other than SCSI ID 0,which is done by changing the configuration of the jumpers or switch located on the device

by nedd

Hi There,

You've the opposite problem to most people! Normally the problem is that the PC insists on booting from IDE every time.

I would suggest that in your setup, the hardware has been adjusted to boot from the SCSI, ignoring the IDE. In most instances, this is done from an "Interrupt 13" setting in the SCSI bios. This should put you in the right direction anyhow.

Sorry for not being more definitive in the way you should proceed - I have not done this myself but know I've read about it somewhere! Best of Luck,

E.

This discussion is closed to new replies.