Discussion Locked

boot up problem

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

its a dell server
on powering on the pc the fans work properly.........the cpu fails to boot up.the light on the motherboard light up
2 months baack there was a ram corruption problem..so installed new ram but now the cpu doesnt boot at all.........where might the problem be ..in motherboard or ram?
Also how to check where the problem is?where is the connection on motherboard for starting the motherboard?

3 replies

by rcom

If you go to Dells support site you can list the serial number (service tag) of the unit and find all info on the original configuration. You can download the setup and service manual for it.

by mccmike

I would do the following:
1) I would check the Dell website using your Service Tag # and look up the specs on your hardware. Make sure that the new memory meets the requirements. Be sure to compare the RAM chips such as the number of chips, the speed (i.e. PC2100 vs PC2700).

2) Make sure the RAM is properly seated. Sometimes with older memory, it helps to remove the memory and use a soft pencil eraser on the contacts to remove oxidation. Make sure you are properly grounded as a static electric discharge could, and probably would, damage the memory chip.

3) Reseat your processor. I have reseated many processors which corrected the problems. Extreme care should be taken as to insure that you do not bend the pins on the processor itself.

4) Reseat all other I/O cards

Good Luck

by davidpaul

If you don't get a single beep (ALL OK), then first check your power supply. If you are convinced that power supply is ok, then pull out your processor and replace it carefully (a loose CPU is often the culprit for no beep). After this if you still get don't get any beep, then don't waste your time in checking RAM and other I/O. Check your motherboard.
Good luck.

This discussion is closed to new replies.