19 replies
by dale joyce Accepted solution
by purpleskys Accepted solution
by dale joyce Accepted solution
by slayer_ Accepted solution
If you haven't made a crossover cable yet, try a normal patch cable first. Some of the new NICs can remap themselves to use a straight cable instead.
My laptop in 2007 could, my 2008 could not, my desktop from 2009 could not, but my 2012 laptop can.
It's a low chance, but easy to try.
by dale joyce Accepted solution
by charles bundy Accepted solution
Slayer is correct, the crossover cable just swaps the Tx & Rx pairs so you don't need a switch. But the only two devices on the network are your Win7 and Win8 PC. So go to Win7 control panel - network settings - adapter. Set an IP4 static address to 192.168.0.1. Goto Win8, click on control panel tile (or right click in the bottom left corner of the display) Click on Network and Sharing center and Ethernet connection. Click on IP4 and hit properties. Set IP to 192.168.0.2. Get to a command prompt on one of the computers and try running the ping command e.g. if you are on the Win7 box type 'ping 192.168.0.2'. If you see packet return you are good. Should be able to share folders at that point or use Windows Easy Transfer PC - PC. You don't need the same OS version to do the above. :)
Hope this helps!
by slayer_ Accepted solution
by slayer_ Accepted solution
So your win 7 would be like this
Default Gateway: 192.168.0.1
IP address: 192.168.0.2
Your win 8 like this
Default Gateway: 192.168.0.2
IP address: 192.168.0.1
by charles bundy Accepted solution
by slayer_ Accepted solution
by charles bundy Accepted solution
by slayer_ Accepted solution
Oh, cool.
I thought the GW was where all traffic was sent, so it was required even for a crossover computer to computer.
by trgscratch Accepted solution
there is also a crossover UTP union
if you determine that you actually need crossover
by dale joyce Accepted solution
by robo_dev Accepted solution
LapLink makes a handy product called 'PC Mover'
480 MBPs and no IP address to set.
I used to use a serial or parallel LapLink cable back in the day when computers used those types of ports.
by dale joyce Accepted solution
by charles bundy Accepted solution
by a.portman Accepted solution
by nicknielsen Accepted solution
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending