Discussion Locked

cannot open volume for direct access

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i have win xp home. i want to run scandisk. when i reboot to run scandisk it gives the message that "cannot open volume for direct access"
i just started getting this message, ran scandisk on here o.k. before. it will just continue to reboot without a scan.

5 replies

by craig herberg

Boot into safe mode -- hit F8 repeatedly when the computer starts up. Run scan disk, then boot normally, and immediately copy everything you cannot afford to lose to your favorite backup media.

Good luck.

Craig Herberg

by jimboputer

i do not understand your reason for coping everything. i did not try to run scan disk in safe mode yet. i can try that. i have zone alarm and also norton professional installed. both have ran for over a year with no problems on scandisk. i do not have service pack 2 installed yet, think this may be the problem?

by craig herberg

Yes, it is quite possible that SP2 will resolve the problem. Regardless, you should at a minimum have a copy of the files you cannot afford to lose.

Craig Herberg

by semmelbroesel

Also check if your computer has any kind of special software installed that protects your hard drive or allows restoring to previous states or allows your hard drive to run.
Possible programs I know of are Adaptec GoBack (encountered on a Gateway PC recently - I could not even mount the drive until I had disabled GoBack in the BIOS) or programs that come with bigger (but older) hard drives that are supposed to translate the size to old computers that theoretically would not work with it, e.g. Seagate used to have a utility like that. With the Seagate utility you do see a message before Windows starts asking whether you want to boot from floppy.
Maybe it is something like that.

This discussion is closed to new replies.