Discussion Locked

Can't ping real IP in LAN w/ CheckPoint

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Dear all,

I have set up CheckPoint 4.1 on NT platform with the LAN and DMZ segments. All the servers in the LAN zone and the DMZ zones have been assigned real IP addresses.

The problem is that the users in the LAN cannot ping the real IP of "some" servers in the LAN zone, but they can ping the real IP of "all" servers in the DMZ zone. What is the cause for that only "some" real IP of servers in the LAN can be ping?

I want the users in the LAN can ping "all" servers' real IP addresses, is there any solution for that?

Best Regards,

WP

2 replies

by turambar386

Hi there.

Sounds like a routing issue.

What is the IP address range and subnet masks you are using in both the LAN and the DMZ?

by wai_pui_law

If this is a routing problem, why there is no problem for some servers on the same zone?

For the LAN, we just use 10.x.x.x with subnet mask 255.255.254.0.

For the DMZ, we use 10.x+1.x.x with subnet mask 255.255.254.0

Best Regards,

WP

This discussion is closed to new replies.