Discussion Locked

Cant see all of the domains in WIN 2000

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
This is using a Windows 2000 Profesional OS on a new IBM Thinkpad T-22 RASing in. The problem is that before noticing the problem, The computer was joined onto the domain and I can see the whole network in Microsoft Networking. We ran into a RAS messaging that could not be done so the Administrator had the name changed. I took the computer out of the domain and put in the new name and rejoined the domain by RAS. I was tolled to update to Service pack two. Installed the Service pack with the Encryption that came with the Download. I see the Service pack was updated but the problem is that I cannot see the other domains in Microsoft Networking but the one I joined. The netware networks are fine, I can see them. I can ping any machine in our network but cant see them. Any questions or suggestion are greatly appreciated. RAS is getting a valid WINS addresses but for some how cant see them.

5 replies

by mind_nt

Hi there:

Delete and reinstall the ras service, then use the dhcp from the server, but put the ip for the dns, and install the service pack 6 high encription pack, if this fail, remove the ip for the dns, and reboot the pc.

After this you willsee the whole lan with your domains.

Regards
Mind_nt

by bjackson

Check your protocols. While most domains will run on IP, check to see if you need NetBUI or IPX/SPX protocols, if so, install them, reboot, and RAS in. You should see all domains if the trust relationship is there.

This discussion is closed to new replies.