Discussion Locked

Can't send email on Verizon

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have 3 PC's networked with a linksys hub/router connected to a Verizon DSL modem. All PC's run 98. Two of them use AOL mail no problem. One uses Verizon mail account for business. I can surf, no problem, I can receive email, no problem.

When Itry to send email it seldom goes out. Sometimes I have to disconnect from the router and plug my PC directly into the DSL modem and launch Verizon's WinPoets program to connect. Then the mail shoots right out.

I've tried pinging the server and using the IP address, as linksys suggested, instead of smtp.verizon.net but I get a relay error.
The error I get most often is...

An unknown error has occurred. Subject 'XXXXXXX', Account: 'mail.verizon.net', Server: 'smtp.verizon.net', Protocol: SMTP, Server Response: '421 mta013.verizon.net Lost connection to [151.202.92.102]', Port: 25, Secure(SSL): No, Server Error: 421, Error Number: 0x800CCC67.

Verizon, of course, says "we don't support networks" and their Tech support is useless. Linksys has not answered my direct queries.

Any ideas?

5 replies

by ann777

Suggest that you open port 25 on the linksys router for the computer (the ip address of that computer) that needs to use SMTP mail. Try that.

by Member 19120408

You have almost an exact duplicate of the situation in my ofice except that I have 5 networked PC's. We could not solve the problem through Verizon and luckily had the opportunity to change to a new DSL vendor which I have just done.
The problemseemed to start a couple of months ago when Verizon made a change/upgrade to their server. Since then some EM gets sent some doesn't. I guess I would try the solution suggested in the first answer but as you know Verizon just won't help with a network problems!
Good Luck! Terry

by n.brodsky

I have since found the answer. The option MTU in the Linksys has to be set for 1492. If you don't have that option upgrade the firmware on line.

This discussion is closed to new replies.