Discussion Locked

cd rom doesn't read any cd's any more

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
what would cause my cd rom to stop reading cd's i do a trouble shoot on it but it always says that the device is working properly yet it doesn't read any cds

11 replies

by bfilmfan

Does it not read ANY CD's or just ones that have burnt somewhere else?

If it isn't reading, time to move up to DVD, as the laser has most likely burnt out.

by gary56789

If the drive actually spins, use a CD cleaner.

Then, if it still doesn't read, locate the correct CD driver (not the one currently on your computer), then unstall the old driver and MANUALLY install the new driver.

It never hurts to unplug and reinsert the data and power cables just in case, however, CD ROM's do go bad, so this may also be the problem.

by nazil dsouza

try using the cleaning kit if it workin orelse try going to the bios give boot from cdrom and boot it with a bootable if this does not work then open it up it not a big thing and clean the lense with a cloth with some perfume spray on it and even try changing the power cable....

by iscool007

Cleaning kits are a good idea but becareful, they can cause damage too if the cleaning brush hasn't been properly maintanted. Read the directions for the cleaning kit carefully.

Also, before try too much software reloading, etc. Simply try the drive in another computer. That should be your 2nd or 3rd step (if not your first) diagnostic test. That will quickly divide your work in half. Based on whether its the drive or the computer. If it doesn't work, try a drive you know works and put it in the computer on the same IDE cable/power cable the suspected bad one was. ETC. Try

by mattit

I'd say ctrservices' advice was the most applicable to the situation. If any of those dont work, chances are your cddrive went bad, but make sure you try all of those first.

Good luck.

by grump

In my twenty two years of expierence with pc's I find the best trouble shooting is done with the basics..
The fastest way to diagnose a CD ROM drive is to bootup with a good ole DOS diskette and cdrom support,(ie if you like the WIN98 Boot disk).

Put you CD in after the system has booted, notice that the LED on the ROM Drive will blink and if it stays on this means drive is ready. Issue the DOS command to access the directory of the CD. If you get a display of the directory then the ROM DRIVE is functioning.

You will need to troubleshoot the problem from a windows aspect.

If you can't read the CD from DOS ; simple replace the ROM DRIVE. :>)

by huntingboy

there is just two possibilities

1. Run a lens cleaner Cd 2 to 3 times

2. It this don't work, it seems lazer is week you have to replace the lens of your cd rom.

by acegolfr

If you tried burning a coping a Win XP cd or a copy write cd it most likely the OS has a built in code which locks the cd and prevents it from working, or it might work but no sound until you find the regestry code to make it active again, look around all websites for the same issues and you will find you are not the only one locked out of your cd burner,

by acegolfr

If you tried burning a coping a Win XP cd or a copy write cd it most likely the OS has a built in code which locks the cd and prevents it from working, or it might work but no sound until you find the regestry code to make it active again, look around all websites for the same issues and you will find you are not the only one locked out of your cd burner,

This discussion is closed to new replies.