Discussion Locked

cd-rw does not work

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When I insert a blank disc,the dialog box still tells me to insert a blank disk.BIOS detects the device.The drive is detected in DEVICE MANAGER,and it says that it is working properly,same as the driver.I have been told to clean the drive.I did,but syill get no rtesult.Waht is wrong?

11 replies

by thechas

How did you clean the drive?
I just read a tip that says to never use the standard CD cleaner disks in a CD-RW drive.
The brush on the disk can damage the more sensitive laser lens in CD-RW drives.

Then, check for updates for your OS and your CD writing software.

Also, if you do not have up to date drivers installed for your motherboard / chipset, the CD drive may not be addressed properly.

Is this a new drive?
Or, one that stopped working?
On my W98 machine, windows update has attempted to install some in-correct driver updates that would stop the whole system from working properly.

If you have XP, you need software patches from both Microsoft and the mfg of the CD software to get the CD drive to work.

Chas

by ggillcom

I did not clean it.My friend did.I think he purchased a cleaner from RADIO SHACK with instructions.The Cd-Rw is not new and was working properly with the same motherboard and OS (GIGABYTE K2-6 500,WIN 98}.

by dave mojozap

It would be that U have a faulty disc, try to use another new disc for writing. I have this experience before & after using another new disc all is o.k. Another solution is to uninstall the software you're using and then install it again. Hope this will able to solve your problem.

by dave mojozap

Always get those good quality type of disc to use for CDRW drive. I have experience when I buy cheap ones to save cost but instead find that it give me lots of problems. Try to turnoff other programs when using the CDRW program.

by st_techrobert

Depending on the type of CD-RW you have, what CD Creator Software you are using,the brand and speed of CD's you have, as well as if you have another CD-ROM or RW installed in your PC, the answers can vary of course. Also, are there any other error messages or dialog boxes that show up? If so this could definitely help pinpoint the problem.
All this considered here is some of my suggestions:
A) Try more than one CD as suggested previously, as well as another brand
B) Check with the CD recorder manufacturer's website for any firmware updates or announcements
C) Most of the CD creator programs have some of testing tool for the hardware as well as the currently inserted CD which can be helpful.
D) Lastly, mostly all Creator programs that I know of are dependent on the CD recorder itself to properly report the state of the CDR/RW media.
--I would bet that the problem lies within your hardware somewhere.
Good Luck

by dcosgrove

Also in addition to all the other comments, it depends on where you got the software. If the software you are using came with a different burner, it may not work with yours. Nero and CD creator are not free, they are included with most new drives but are modified such that the software can not be shared.

by ggillcom

You are right.The CREATOR program that I am using now did not vome with the Cd-Rw.ACER is the manufacturer and they no longer provide support for their products.If anything you suggest does not work,I think it would be better to buy a new CD-RW.They run about $70.00 + and come with the software.Thank you for your patience.I really appreciated your help.

This discussion is closed to new replies.