Discussion Locked

Cloned HDD 40GB...Says 3.4GB !!

0 helpful
16 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I cloned a 3.4GB HDD to a 40.0GB HDD using Ghost. The source HDD was Win98 (NOT Win98SE) The cloned HDD was updated to WinXP PRO...now the problem is that the cloned HDD says it has 2.93 GB TOTAL !! I don?t remember how to get the HDD to show its actual size.
How can I clone a 3.4GB HDD to a larger HDD and keep the size of the Destination HDD...I have done it before but I think it happened without me purposely doing it...Any tips?
One other thing I went straight from the regular Win98 to WinXP PRO....
The PC is 800MHz VIA Samuel 2, 128MB RAM....

16 replies

by blackcurrant

Hi

Seems that the destination drive has just a 3.4GB partition on it. You should be able to use Fdisk to allocate the remaining space to one or more partitions which will show up as separate drives.

Good luck

by willcomp

Normally Ghost will use full drive by default when cloning drive to drive. Did you by any chance select partition instead of drive?

Dalton

by liame

As the others have mentioned it sounds like you cloned the partition rather than the disk.

You could use fdisk to create a drive in the remaining space as said previously giveing you a result like...c: size 3.4GB and d: size 36GB. If you did that though i think the lack of size on the system partition would become a big PITA sooner rather than later, better to sort the problem out now.

2 options

1) Reclone and use the whole disk, which may not be feasable if you've done work on the new drive since the clone.
Or...
2) Use a utility like partition magic to increase the size of the partion to use the free space. If you hae it / can get hold of it this really is the best way to go.

by melvin_780702

Try this bro in win98....first partition and format your 40 GB as you desire, I pressume you prefer only one drive...after formatting, slave your new drive into your system...boot as you normally would in your 3.4 GB....Click start...then run....type xcopy c:\*.* /k/e/r/c/h d:\ .....this will clone your 3.4 into the 40 GB....

GoodLuck

by wlbowers

There are several programs that will resize an active partition.

Partition Magic is one I use the most.

Good Luck Lee

by davidpaul

As pointed out earlier you have obviously cloned the partition and so the cloned HDD has taken the size of original HDD. Your unused space is still there and you can use the relevant disk manager to claim the remaining space or use parition manager to resize the partition.

One other thing: If you are using XP, then clone the partition using XXClone to destination partition.

This discussion is closed to new replies.