Discussion Locked

cmos

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

1) every time i open my pc, it cannot detect the hard disk.I've to go to cmos and detect it.why it's happen and how to make it detect by itself.

2) hd detect as sec slave.even though i've change the ide cable,jumper and user setting.

3)what isthe function of cmos and how to use it.

hope the members there can help.

5 replies

by craig shepherd

3) The function of the CMOS is to identify the components of your computer and set up basic comunications between them, hence the name BIOS (Basic Input Output System). And finally boot the OS installed.

The manual which comes with your motherboard will have all the available parameters and what they are for. You can also download these from the net.

2) Check to make sure you don't have a special CSel (Cable Select) Cable. If it's an 80 conductor cable make sure that you use one of thetwo close together plugs for the HDD.

1) It would be a good idea to check the version of you BIOS and then look for an updated version on the net. An updated BIOS may have fixed some of the problems you are having.

by vivisector

First of all, it is keeping proper time, it sounds like you may require a new CMOS battery. Make sure your jumpers on your harddrive are set to master, also make sure you have the hard drive cable plugged into the primary IDE controller connector.
CMOS/BIOS is just a listing of hardware you computer checks when booting up. Also has adjustable settings for systemboard, such as power management options. It runs off a battery, (usually a clock battery), older machines have a battery pack attached to the systemboard, which will cost more to replace.

This discussion is closed to new replies.