Discussion Locked

CMOS Settings are wrong

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I recently purchased a computer and set it all up, and when I started it all that showed was a blank screen. I reset the cmos and then I was able to get into bios. I have to reset the cmos everytime I want to start up the computer. When it starts it says that my cmos settings are wrong, and it gives me the option to go into setup or use the defaults. If I use the defaults the computer stays on but nothing happens on the screen.

Here are the components I bought.

http://www.newegg.com/app/viewProductDesc.asp?description=13-130-434&depa=0

http://www.newegg.com/app/viewProductDesc.asp?description=14-102-361&depa=0

http://www.newegg.com/app/viewProductDesc.asp?description=20-145-450&depa=0

http://www.newegg.com/app/viewProductDesc.asp?description=22-152-010&depa=0

Those should be the only components that would cause some cmos settings to be wrong.

Can somone tell me which bios settings may be wrong with these components? Thank you, I have been trying to fix this problem for a couple of days now.

7 replies

by willcomp

Try these and post results.

1. Disconnect all drives and remove all cards except video card.
2. Remove 1 stick of RAM
3. Boot up and see what happens.
4. If problem persists, swap RAM and try again.
5. If all is OK with first stick of RAM, install second stick and see what happens.

If system boots OK after adding second stick of RAM, start adding other drives and cards one at a time until problem recurs.

You have now passed basic troubleshooting 101.

Good luck.

by willcomp

Have built 2 systems with same mobo and 3200+ CPUs. Both had radeon cards and Kingston PC3200 RAM. No problems with either system.

by chris2084

Thanks, it actually turned out that I had to set the cpu voltage to 1.4? Whatever, it worked. I now have a new problem, however this is one that can only be answered through guess and checking.

by chris2084

Also, when I choose to boot from the hard drive from bios, it will run windows xp, but when it gets to "windows is starting up" or "applying computer settings" it hangs there.

I was able to install my OS by choosing to boot from the cd drive in bios.

by bilal2002

1. I would Check the MSI web page for known bugs with the M/B version,revision number.
2.Check for lastest BIOS Firmware update and see if it mentions your problem in the fixes, and follow the update procedure.
3. Make sure you havn't applied the jumper on the M/B to default the BIOS every time you boot up.
4.If you have no outcome with the above I would check the compatability of the memory,videocard with the motherboard. If fine I would return the M/B back to the supplier and have them test it with you parts. If the Mother board or any part if faulty they would replace it.

by p.j.hutchison

Make sure the CMOS/BIOS battry hasn`t come loose or got lost in transit. It might look like a small silver circular item on motherboard. For the CMOS to keep its settings, a battery has to be present to keep them in memory when PC is off.

This discussion is closed to new replies.