Question Locked

Coax to RCA

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an atari 7800 which has a single output source like many old systems. This output plug looks exactly like a single RCA wire. The only problem is that it is just like a Coax wire. In other words, this single wire contains the audio and video needed to play the system. The question is what is the easiest way to convert this single wire output into the modern 3-wire RCA cable.
I know I can convert this plug to Coax and run it through my VCR, but i am already using that for something else. And I don't want to spend $100 for an RF Demodulator since I am thinking there MUST be an easier way. Coax wire can hold multiple channels so I can understand that its a problem to convert a normal cable tv signal to a 3-wire RCA connection, but in my case, this wire has only one output on channel 3 so why can't i just take that single wire output and convert it to three-wire RCA cables without using hi-tech devices.
ANY ideas from our technical experts on this forum are welcome and appreciated.
Thanks.

3 replies

by robo_dev

The problem is that what comes out of that RCA jack is RF modulated Audio+Video on an RCA plug

The atari is putting out a broadcast signal, and converting that back to a video signal requires a radio receiver that can tune in the right frequency and convert the radio waves to audio waves and video signals. (the name for that part is a RF Demodulator).

If it were easy, then people would not have built custom mods for the Atari, as this guy did, with a lot of hard work:
http://www.geocities.com/atari7800mod/

RF Demodulators are hard to find, here's one:

http://www.electronicplus.com
33-2060 MONAURAL RF DEMODULATOR-CONVERTS RF (CABLE TV or ANTENNA SIGNAL) TO COMPOSITE VIDEO & AUDIO SIGNALS. COMES IN A BLACK BOX (3-1/8" x 4-3/8" x 1-3/8") WITH CABLE TV "F" INPUT & RCA VIDEO (YELLOW) AND RCA AUDIO (RED) OUTPUTS. COMPLETE WITH AC ADAPTER. $99.75

by thechas

As Robo_Dev stated, the RF demodulator IS the easy way.

Sure, you could build your own demodulator. Or, open up the box and get at the signals before they enter the modulator. But both of these options will usually end up costing you more than the demodulator would.

I recommend that you search online electronics surplus sellers and your local second hand stores.

Some of my online sources are:

www.allelectronics.com
www.bgmicro.com
www.hosfelt.com

If memory serves me correctly, you will only get video and monaural sound from an old Atari.

Also, the resolution will be disgustingly low on a modern HDTV system.

Chas

This discussion is closed to new replies.