Discussion Locked

Comm ports hung open

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a Dell 400 server running Win2K server with an external modem. Both comm ports are in the "open" state, cannot close them. Does anyone know of a utility to force them closed? I've also tried to install a PCI serial port card, but Win2K server will not recognise the extra two ports.

4 replies

by jonathanpdx

1. Is it really an external modem or is it a cable/DSL "modem" router?

2. How do you connect the "modem" to the server?

3. Are you referring to COM ports (COM1, COM2, etc.) or "comm" as in communications in general? I'm assuming the first as you refer to adding a serial port card.

4. Have you tried disabling the "comm" ports in CMOS, or setting them to AUTO?

5. Is it a Dell GX400 or a different model?

Thanks!

by willcomp

Usually, when I've see open COM ports, problem was either a failed modem or faulty modem driver. If either one is the case, a reboot will reset ports until modem is initialized and ports will once again lock open.

Dalton

by willcomp

About add-in serial card. Win2K doesn't share interrupts or addresses well, so you probably don't have any available interrupts for the other 2 ports. Can try disabling on-board serial ports and then installing PCI card.

Also check to ensure that no other devices are interfering with COM ports. Unless you added hardware, shouldn't be the case.

Dalton

This discussion is closed to new replies.