4 replies
by dmiles
Gee, I think you have either bad ram or not enough power. I would remove any extra fans, cards, disconnect all drives except for the boot drive and floppy and see if it will run stable. You want to try to remove as much load from the power supply as possible.
If it still won't run it's either ram, cpu, or mobo. It's hard to eliminate any of these without having an other computer to test the parts or new parts to replace.
Strip the machine down to the bare minimum to eliminate as much as you can.
Looks like you have all ready ruled out the ram, next I would try setting the bios settings to the fail safe or most conservative settings. Hope you can track this problem down, good luck.
by zzy1000
As a quick step sequence:
1. Enterning BIOS, go to "load default value", load and save.
2. Try to remove one memory module and use the left in different slots.
Now you can determine which memery is bad.
by hereinoz
I have seen this caused also by a shorted 80 conductor IDE cable.
Unplug everything and remove all PCI and other devices except the video card, one memory stick & the CPU. Even unplug the IDE and floppy drive cables and see if the board will get to the point of testing for IDE devices. If it doesn't, swap the memory stick. If it still doesn't get past the memory check it is probably motherboard or CPU (unlikely that it is CPU at this stage - usually that causes total failure to start)
If it does boot to the point of looking for IDE drives, start by adding the floppy drive, and see if you can boot to DOS with a DOS start up disk.
Then add devices one by one until you hit the failure.
cheers,
Alan
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending