Question Locked

Computer goes to autoplay and then stops when I insert sandisk card

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
All of a sudden I can't get my pictures off of my sandisk card. When I put it in the slot it goes to autoplay and then nothing. What could possibly be wrong with this?

4 replies

by thumbsup2

Could be a reader gone bad. Could be a bad card. Could be drivers. Could be lots of different things, including a virus. Tell us a bit more please.

You said "goes to autoplay and then nothing". By nothing, do you mean the computer locks up and you have to reboot? Does it appear to be trying to read the sandisk card? Do you get a drive letter assigned to the drive in My Computer? Can you eject the card through My Computer? Can the camera still read the card? Can you plug the camera into the computer and read it from there?

Did you observe any other abnormalities at about the same time this started to happen?

And finally, our favorite question! What operating system are you using?

by scottandnancy92

Ok so this is what happened, my D drive was the one that should of been reading my sandisk card....it kept saying insert cd. Although I put the card in the slot nothing would happen, like 3 minutes later autoplay would pop up and do its thing then nothing more would happen, autoplay just closes out.

When I go to My Computer and click D it takes forever for it to open and then says nothing is in there, sometimes My Computer folder will lock up.

I am using Windows XP Home, I haven't installed or uninstalled anything that would make my card not be readable anymore. I have also tried 2 other sandisk cards :(

When I go to Disk Managment it was saying unreadable under D, but now it says no media.

by scottandnancy92

And here are the steps I took to do so:

Go into Device Manager
Expand Universal Serial Bus Controller
Right click USB Root Hub
Click Update
Click Install from a list
Click Don't Search
Click Have Disk
Click Browse
Click C
Click Windows
Click INF
Find "usbstor"
Click ok
Click Next
Click Finish

do this for all showing USB Root Hubs

This discussion is closed to new replies.