9 replies
by systemcheck Accepted solution
by jck Accepted solution
155F is too hot even at load. that's almost 70C.
a) get some Arctic Silver 5 and try reapplying the TIM again.
b) make sure your heatsink is clean
c) make sure the fan is pulling air well across your CPU
d) make sure the case filters/meshes aren't clogged and your fans are bringing in adequate airflow into the case.
e) check to make sure that your CPU Volts is set to the factory default, as are your clock speed. overvolting causes more heat as does overclocking.
If you're running anything smaller than a 120mm HSF, get a 120mm. Even the Sunbeamtech Core Contact Freezer 120mm for Intels is good and it's plenty cheap.
Hope it works out for you. Good luck.
by systemcheck Accepted solution
by ---tk--- Accepted solution
First I would think a duel core running at 3.0 is going to run hot in the first place... Probably around 55-60C stock, so the first thing I would do, is get an aftermarket heatsync + a faster fan. What is the model of the CPU?
As far as your GPU's and system, those temps look about normal (to me).
I would look at the "recommended" settings for your CPU, and memory... your Motherboard might be overclocking them, with out you knowing about it. So check out what is recommended, and then check what the BIOS is setting them at. Then make the correct changes...
by jck Accepted solution
if it was your mobo overvolting your CPU, it would report in the diags/monitors in your bios.
If it was your CPU, it would have fried if it was unstable like that and putting off a lot of heat.
not that i'm talking down to you or anything, but i don't know how familiar you are with applying TIM and what not. So, this isn't meant as an insult or anything.
When you put TIM on the CPU, first make sure to clean both the CPU and the HSF completely and have a shiny surface on both.
When re-applying, make a bead about the size of one green pea on the top of the CPU. Then using a flexible flat item (such as a clean, plastic coated business card), smooth the paste across the whole surface of the CPU as thinly as possible.
Then when seating the HSF onto the CPU, remember not to pull the HSF back up from the CPU and TIM, or it can cause an air pocket in the TIM which will drastically reduce thermal dissipation.
And again, getting a new, good, cheapy HSF like the Sunbeamtech 120mm might not hurt as a last resort if nothing else does the trick.
Hope it works out for you.
by ---tk--- Accepted solution
After reading through a few reviews... 20 pages of 48, on this motherboard, there were a few things that was talked about more than a few times.
Watch/check the voltages on the RAM, apparently this board has a tendency to under volt your ram. Which will cause system instability.
The north bridge will get very hot, a couple people have placed fans on it, which helped. also like JCK stated... If you do not set the heat sync properly, your CPU will cook (stated more than once)...
I would also look at your BIOS version, apparently asus has released a few updated versions...
by systemcheck Accepted solution
by ronilo_tadlejr Accepted solution
maybe 5 notches down or 7 this could make your pc more relax...
try to overclock it down.
this is what i do when i encounter some pc which is the same as your complaint.
keep it cool dude.
by systemcheck Accepted solution
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending