Question Locked

computer turns on then turns off 1 second later

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just finished building a new computer for myself, and when i turn it on, it turns off after 1 - 3 seconds. i know it is on, because the LED's in the ram and the fans come on, and all the case fans and cpu fans come on. after it turns off by itself, the power button on the case has no effect.

12 replies

by retro77

You are not making it through the POST. Look in your motherboard manual and make sure that the RAM you ahve installed is compatible. check the CAS, Latency etc. Also try booting with only one RAM stick if you are running more than one.

Do you have the extra 4 pin power connector plugged into the motherboard? Try booting with no video card also, just so you can get some error beeps or successful beeps.

by mjd420nova

On all of my builds, I replaced the standoffs with nylon or plastic. This eliminates the need for the insulating washers on the underside of the MOBO. These washers, either missing or dislogded can cause exactly the fault you are seeing. The power supply shuts off to protect itself, and with a major fault on the 12 volt it will not turn back on right away until the current drains off and the circuit can reset itself.

by rob miners

You could also try reseating the CPU and make sure that the CPU Fan is correctly in position. An incorrectly seated Fan can cause these symptoms.

by westin.ripley

according to the manual when LED1 is on, and LED2 is off, it is a memory error. iknow the memory is compatable, and tried it in the other two slots. what else should i try?

by rob miners

You are using a new power supply I hope and did you apply the heatsink gel?

by emosteve

Make sure the power button is springing back after you push it. Otherwise it is like holding in the button to force a shutdown.

Came across on like this recently.

by jrchristman

I've had a similar problem and it turned out
to be that the momentary contact switch was not a momentary switch at all. Another thing to check would be if the switch is stuck or doesn't spring back.

by reddoghh

My problem was that the paste that I used between the cpu and the fan was not working correctly. I did not put enough paste in between. There is a safety feature that detects abnormal rises in temperature of the CPU and automatically shuts down. After buying new paste (very expensive 8?) and starting up again it all worked fine.

by abe_nix

if the processor fan is not tight against the cpu than alot of the Intel cpu's will kill the power to stop you from burning up the processor. I had this problem building my last system.

by jah7_85

One of the little plastic piece's the holds the fastner's to hold down the heatsink fan snapped off creating a gap and causing the computer to shut itself off.

by kouroum

here it turned out to be faulty Ram module... changed the Ram and now it's working perfectly...

This discussion is closed to new replies.