Discussion Locked

computer wont boot

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

This computer was working fine. I removed the video & hard drive for approx a month to use in another computer. When i refitted the video card and hard drive back into this computer it will no longer boot. The hard drive and cpu fan spin up etc but there is no output to the monitor at all and no beeps from the system speaker. I have tried the video card and hard drive in another PC and both work fine. The monitor is ok because it works with other systems. I have tried another known working power supply and speaker in case of problems there. it seems the system hangs during the post before anything is displayed on the screen but it gives no error beeps. I have stripped the motherboard down and reassembled it to eliminate things such as chipcreep in the cpu or memory modules but still no luck.
Can anybody suggest anything I can try or how can I tell if the M/B is faulty without replacing it?
The components I refitted (video card & hard drive) were the oringinal parts from the system.

12 replies

by cwunder3

I would try resetting the CMOS. Set CMOS settings to the default and try to find the IDE HDD again.

by pctech

The boot process wont even get to the stage of allowing me to enter CMOS ... there is no output to the screen at all.

by srojas

Try replacing the memory, sometimes it's the memory that is bad and it will not display any video.

by pctech

I have replaced the memory with a different sort but it didnt have any effect at all ......... i thought it would still give error beeps due to bad memory modules?

by thechas

I concour with answer 1.
You do not need to boot to reset the cmos data.
Check for a jumper on the motherboard to clear / reset the cmos.
Set the jumper to reset.
Boot,
Shutdown,
Set the jumper back to normal.
Boot again.

If there is no jumper, remove the CMOS backup battery, and unplug the computer.
Let it set for 30 minutes or longer.
Check that the battery is okay. (lithium cells should measure 3 volts with a voltmeter.
Replace the battery, and attempt to boot.

Make sure thatthe video card and drive cables are fully seated.

by twistypigeon

If it is then if you've done anything slightly out of the ordinary with the hard drive you removed then you could have wiped the BIOS!
Helpfully some (if not all) Compaq machines have their BIOS on a small partition at the start of the hard drive. If you remove the drive and use it in another machine, maybe wiping this unknown partition, then when you return the drive the machine has no BIOS and so no idea what to do!
If this is the case then you could go to the Compaq web site and hunt for the correct BIOS version, reinstalling it on a small 2Mb partition.
If none of this is relevant then ignore me!

8)

by pctech

Finally found the problem. I had overclocked it 18 mths ago and it ran perfect so now just as a experiment I reset the jumpers to the correct speed and it booted up perfectly ... seems strange it ran for so long overclocked and then suddenly decided it didnt like it anymore. never mind problem is now solved so thanx to all who contributed for your time and suggestions

This discussion is closed to new replies.