Question Locked

computer wont start

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently purchased a new comp case to replace my older one I got everything put in the new case and pluged everything in but it wont start up the only response i get is the processor fan light shines but shuts off

3 replies

by mjd420nova

The biggest fault causing problem on MOBO replacement is the missing insulating washers between the MOBO and the standoffs it mounts on. Look for them in the old case, sometimes they are glued to the board but can fall off. This would allow the power supply to short and exhibit the fault you see, the P/S tries to start but faults out and stops.

by link470

What I usually do when that happens to me is take all the components out, carefully placing the motherboard and being sure not to have metal in direct contact with the case like the previous poster mentioned with the washers. Then add the processor and CPU Heatsync. If you use onboard video, that's all you need. If you use a video card, plug that in as well. Then power on the computer once you plug in the power supply and see if anything comes up on your monitor. No IDE or SATA devices or other expansion cards. Just your monitor plugged in, maybe a mouse and keyboard if for some odd reason the board whines if it doesn't have those and won't show anything on your display. If you're successful, keep installing components.

This discussion is closed to new replies.