Question Locked

Connecting 2 Netgear WPN824 v2 Routers together for extra compters

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
How do I connect, via ethernet cable 2 Netgear PNP824 v2 Routers together to increase the number of computers on a network, sharing a brondband connection?

3 replies

by robo_dev

Plug it into your one router, and you're all set.

However, with what you have:
Assuming that the first router is connected to the Internet.

Then you would need to do the following to the second router:

- Disable DHCP on the secondary router
- Connect a cable from a LAN port on the first router to a LAN port on the second router.

This would make the second router act as a simple ethernet switch. Not a good way to do it, but it works.

Best bet is to just buy a simple ethernet switch and plug it into the primary router if you need more ports.

by oh smeg

Will do the same job. You run the CAT cable from the output of the router to the Uplink port of the Hub and then connect the computers that you want there.

Should cost about $40.00 for a decent 8 Port unmanaged Hub and less if you buy a cheap one.

Col

This discussion is closed to new replies.