Discussion Locked

Connecting a cisco router to a network

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hello gang. I received a call from a recruiter today and the recruiter indicated she needed people to connect cisco routers to networks. Please bear in mind my background is primarily with desktops, laptops, etc and the support realm, and I haven't really done much with routers and switches, etc. I've installed routers in racks a few times but that's it. No configuration. I told her this and she indicated they only need people with an A + Cert which I have to connect the Cisco routers to networks. I assume they'll be some training but am I making too much of this. What else could be involved and is there any prep work I could do on my own to prepare. Thanks

2 replies

by hal 9000

There really isn't much involved at all. The main issues will be with the ISP and that is generally a sit and read as you setup the router to the necessary specs required.

Col

by mat hancock

I wouldn't expect any training, but perhaps I'm a pessimist. You will need to understand the different 'access levels' of the switch, and how to switch between them. Each one allows or denies a different level of functionality - grab the manual for the particular model if you can.
You should also have a clear grasp of router tables and subnetting, do some web research on IPv6 to give you a clrearer idea of how to set up efficient routing tables.
Most switches these day have a web interface to set parameters, so you shouldn't have any problems pointing them to the router if you have to.
Lastly, keep in mind protocols apart from tcp/ip that might be needed, say for network booting for example.
Good luck!

This discussion is closed to new replies.