16 replies
by ozi eagle
Assuming you have removed the HDD from the laptop, then the adaptor plugs onto the back of the HDD. Note that there are four pins, somewhat separated from the rest, that aren't used. Pin 1 of the umpteen way connector is next to these four pins.
Now plug a normal IDE cable onto the adaptor. Make sure that the HDD is jumpered as slave or installed as secondary master. The power adaptor plugs into a spare drive power plug.
by cyberghost_1
Poster rated this answer.
by cyberghost_1
by cyberghost_1
by willcomp
Connect the notebook drive to the secondary IDE channel of mobo. In a normal setup, simply remove IDE cable from optical drive(s) and connect to notebook drive.
You will need to boot from installed drive on desktop. Notebook drives are not master/slave selectable so they must be installed as only drive on secondary IDE channel or connected to an add-in controller card (e.g. Promise Fast Trac).
Have done such a number of times and will work if connected properly.
Dalton
by willcomp
by cyberghost_1
Poster rated this answer.
by rindi1
by cyberghost_1
Poster rated this answer.
by statykserver
by cyberghost_1
Poster rated this answer.
by ryfry9
by cyberghost_1
Poster rated this answer.
You must connect the drive as a slave on the secondary ide . Select the bios and detect the drive when you restart.
It may happen that you can see the drive n the bios but not in windwos . You must then go into the administative tools and the drive management to all ow the drive either be mounted or accepted by windows , you will then require a restart to recover the data you need.
by cyberghost_1
Poster rated this answer.
by cyberghost_1
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending