8 replies
by dennis.rhine
by paulp
command.com lives at the root of c: on a window98 PC - C:\
Boot to your Windows98 startup diskette. At the C: prompt type SYS C: then press enter. This should take only a couple seconds. Remove the floppy and reboot the PC. If you accurately decribed your problem, it will now be cured.
by kyork
by kyork
by oz_media
YOu either have a dead command.com file or it is missing from the floppy disk.
Try making a new boot disk on a working computer (Just cliks Add/Remove Programs and there is a tab for creating a startup disk.
Another solution: http://tinyurl.com/3mkzu
Good luck
by blackcurrant
Hi
Have you tried creating a boot disk from another Windows98 machine? Do that, then boot from the new floppy which should take you to an A:\> prompt.
Good luck
by cglrcng9
Did you wipe out all former partitions using FDISK or just Format C:\? Have seen on many HP's and Compaq's that have a D:\ System_Save partition, where some just wipe out the DOS partition (Partition 1), and left the extended and logical drive partition, System_Save drops from D:\ to C:\ and cannot be accessed since it is not a DOS partition. Re-FDISK, and partition (look at all partitions using option #4), go backwards through #3, then #2, then #1. restarting in between operations. Then restart, set up a DOS Partition and make it active. Restart, Format C:\, restart. Then follow below.
Are you absolutely sure the machine is a Win98 machine or could it be Win98SE? Go to another computer armed w/ a couple of floppy disks. Go to www.bootdisk.com and download onto the machine the following. Windows 98 OEM, and Windows 98SE OEM. Double click on each file to unpack the disk creators. Put a floppy in the A:\ Drive and double click on the disk creator and label each floppy. Now go to the laptop in question. W/ NO CD in the drive, Insert Win 98SE Boot Disk and attempt to boot to the A:\> Prompt. Repeat w/ Win98 OEM disk if not.
If you don't get to the A:\> Prompt w/ 1 of them I'd be looking @ hardware or BIOS settings.
If you do get to the A:\> Prompt just type SYS C: (Enter), then allow files to copy to C:\.
Now Type E:\ (Enter) and it should switch to E:\ Drive. (If you booted choosing Start Computer w/CD option the CD drive(s) message pointing out what drives are CD Drives). Replace E:\ above w/ your actual lowest loaded CD Drive letter.
Now put the Windows 98 or 98SE Setup Cd in the CD drive. (I then always check by typing DIR (Enter) to make sure the list of files seen on the drive match my Setup CD and not say the virtual RAM Drive). Type cd Win98 (Enter), then type SETUP (Enter). It will run a Scandisk and then Setup.
Are you positive after Partitioning using FDISK, that you actually restarted & Formatted the drive? (Format C: from the A:\> Prompt) A
by cglrcng9
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending