Discussion Locked

Defective Power supply for HP Pavilion?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I replaced the power supply for an HP Pavilion with the correct model for the system and still can't get the PC to boot up. the fan is running on the new power supply. Could this be a mainboard issue? Please advise.

3 replies

by thechas

Yes, it could be the motherboard, the CPU, or any plug-in card.

My guess is that this system suffered a surge to the phone line during a thunderstorm.
The internal modem was destroyed, and damaged the motherboard.
The motherboard then drew a sudden spike of current that took out the power supply.

To confirm, take a close look at the motherboard.
You are looking for burnt or bulged components.

Chas

by harleydatasun

'The Chas' may be right. It could have been caused by any number of reasons. The first step I would have taken is the one you've taken, get another power supply, especially if you could verify that the old power supply's fan was not working properly (ie power supply fan). I would then check for the system fan and CPU fan. If neither are working, replace the motherboard. If the motherboard got fried. It could have also fried the CPU, memory, hard-drive, or any other component. The order of replacement I would take until I got a positive POST is.

1.Power Supply
2.Motherboard
3.CPU
4.RAM
5.Video Card
6.Hard Drive

Hope this helps.

by grump

When you say can't get the PC to boot up are you talking about booting to an operating system or getting a POST display? The term boot up was coined from the old days loading an operating system.
If you get a primary display when you power on the PC , try booting from a bootable floppy disk.

When you trun on the PC and the only thing you get is the fan running on the power supply then your problem is hardware related.

The following item required to for PC to POST are as follows.

Power (Power Supply)
Processor Chip (CPU)
Memory ( RAM)
VIDEO ( most HP Pavilion have on board video)
Keyboard connected.

Try this.
Unplg Power cable to HD, CDROM and FLOPPY
also disconnect the I/O cables to the above devices.
Remove any add in cards, form expansion slots.
Now power on the PC and see if you have a basic POST display.

Power
On
Self
Test

POST

If no display you have system board problems.

Good Luck'

This discussion is closed to new replies.