I do not believe that you can disble this option. However if you can it would be in the Bios. You can get to the Bios different ways depending upon what type of bios you have. If you have an IBM computer you press f1 or f11 after you start your computer from a cold boot(not a restart. If you have another type of computer you can watch the screens as the computer boots up you will see a message that says to enter setup press(should be something like esc, f1, f11, etc).
I would agree with the other answer in that it could be that the new drive is not set-up as a secondary drive. You should refer to the manual that cam with the drive to make sure that the drive is set to secondary position. I had a similar problem once and even after settingthe drive to seconday position I still had problems. This was an older computer so I set the second drive to cable select and put it at the end of the cable with the primary drive being the first drive on the cable. This fixed the problem on this computer. Again if you refer to the manual you will see how to set the drive up as a cable select device.
If you do not have the manual I am including a link so that you can see the diagram of a western digital drive. Most drives are jumpered almost the same.
http://www.wdc.com/service/FAQ/jumpers.html